You could even use pocket holes if you so choose from the inside of the carcass. Dowels or biscuits can work equally as well. The domino isn’t necessary for this build. For that I like to use my DFM tool works small square and work from the inside of the carcass and lay everything out while the carcass is mocked up. I dry fit everything first so that I can mark out where my domino mortises are going to be in the corners. I use a chisel to knock out the rounded corners left by the pattern bit. I use a cutoff piece to make sure I nail the thickness perfectly for the dado and this dado stops one inch from the front of the carcass to accommodate for the eventual drawer fronts. I measured up a stopped dado on the insides of my top and bottom panel and then put down some painters tape which is going to get some CA glue as I build a plywood guide for the pattern bit on my router. In an effort to get everything identical, I gang cut my opposing sides so that everything is perfectly matched. In the interest of efficiency, I clamp my panels side by side so that I can use the track saw to cut 45 degree mitered corners all at once. Afterward, I shore everything up to final dimension on the table saw. The carcass itself can be built with one or two sheets of ¾ inch ply. I have a few sheets of plywood here that are mostly leftovers from another job I worked on. Don't mind the morbid name.Īnd every large sheet good job starts with breaking everything down to rough size on the track saw. Every good cabinet job begins with a carcass.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |